Label Gone Timeout - Datalogic QuickScan Lite QW2100 Product Reference Manual

References

Label Gone Timeout

This feature sets the time after the last label segment is seen before the reader prepares for a new
label. The timeout can be set within a range of 10 milliseconds to 2,550 milliseconds (2.55 sec-
onds) in 10ms increments. Label Gone Timeout does not apply to scan modes that require a
trigger pull for each label that is read
Follow these instructions to set this feature:
1. Determine the desired setting in milliseconds.
2. Divide the desired setting by 10 (setting is in 10ms increments). Pad the result with lead-
3. Scan the ENTER/EXIT PROGRAMMING MODE bar code to enter Programming
4. Scan the bar code: SELECT LABEL GONE TIMEOUT SETTING.
5. Scan the appropriate three alpha-numeric characters from the keypad in
6. Scan the ENTER/EXIT PROGRAMMING MODE bar code to exit Programming
This completes the procedure. See
Table 2. Timeout Setting Examples
STEP ACTION
1 Desired Setting
Divide by 10 (and pad with leading
2
zeroes)
3 Scan ENTER/EXIT PROGRAMMING MODE
4 Scan SELECT LABEL GONE TIMEOUT SETTING
Scan Three Characters From
5
Appendix E, Keypad
6 Scan ENTER/EXIT PROGRAMMING MODE
244
ing zeroes to yield three digits. For example: 0 = 000, 5 = 005, 20 = 020, etc.
Mode.
Keypad representing the duration which was determined in the steps above. You will hear
a two-beep indication after the last character.
If you make a mistake before the last character, scan the CANCEL bar code
to abort and not save the entry string. You can then start again at the begin-
ning.
NOTE
Mode.
50ms
005
'0', '0' and '5'
Table 2 for some examples of how to set this feature.
EXAMPLES
150ms 1800ms (1.8 sec.)
015
'0', '1' and '5' '1', '8' and '0'
Appendix E,
2550ms (2.55 sec.)
180 255
''2', '5' and '5'
TM
QuickScan Lite QW2100