Label Gone Timeout; Productivity Index Reporting (Pir) - Datalogic Magellan 1100i Product Reference Manual

Label Gone Timeout

This feature sets the time after the last label segment is seen before the scan-
ner prepares for a new label.
START / END
Sets the label gone timeout duration using hex values from 000 to 255 in increments of ten milliseconds (10ms or
0.01 seconds). To configure this feature, scan the "START/END" barcode above to place the unit in Programming
Mode, then the "Set Linear Label Gone Timeout," followed by the three digits (zero padded) from the Alphanumeric
table in Appendix C, representing the desired time value. Exit programming mode by scanning the "START/
END" barcode again.
DEFAULT SETTING FOR THIS FEATURE: 320 milliseconds (032)

Productivity Index Reporting (PIR)

When PIR is enabled, label quality data is appended to decoded data before
being presented to the POS. The PIR feature allows the scanner to provide infor-
mation to an external computer, indicating how easy the label was to read.
NOTE
Disable
DEFAULT
10
PROGRAMMING BARCODES
This value-added feature is a factory-programmed option. Contact your
dealer for information about upgrading your system to include this
advanced capability.
PROGRAMMING BARCODES
Set Linear Label Gone Timeout
START / END
Enable
Magellan™ 1100i Scanner