Datalogic QuickScan Lite QW2100 Product Reference Manual page 275

Label ID: Set Individually Per Symbology — continued
Table 18. Label ID Examples
STEP ACTION
1. Scan the ENTER/EXIT bar code
Determine placement of the Label
ID characters BEFORE or AFTER
with regard to scanned data using
2.
Label ID Control on
page 71
Scan the bar code selecting the
symbology type you wish to
designate label ID characters for
3.
Label ID Symbology
using
Selection, starting on page
72
.
Custom Label ID example (desired
4.
characters):
Find hex equivalents from the
ASCII table (inside back cover),
then scan in these digits/
characters using the bar codes in
Keypad, starting
the section:
5.
on page 297
. f you make a
mistake before the last character,
scan the CANCEL bar code to
abort and not save the entry
string. You can then start again at
the beginning.
6. Scan theENTER/EXIT bar code
Scan the ENTER/EXIT bar code
7.
once again
Result:
Product Reference Guide
(Reader enters Programming Mode)
Enable as Prefix Enable as Suffix
GS1 DataBar
Code 39
Omnidirectional
D B * = C 3
44 42 2A 3D 43 33
(Reader exits Label ID entry)
(Reader exits Programming Mode)
DB*[bar code [bar code
data] data]=C3
Label ID: Set Individually Per Symbology
EXAMPLES
Enable as Prefix Enable as Suffix
Interleaved 2 of 5
+
2B
+[bar code data] [bar code data]PH
Code 32
P H
50 48
265