Label Id: Set Individually Per Symbology - Datalogic QuickScan Lite QW2100 Product Reference Manual

References

Label ID: Set Individually Per Symbology

To configure a Label ID individually for a single symbology:
1. Scan the ENTER/EXIT bar code.
2. Select Label ID position as either BEFORE (Enable as Prefix) or AFTER (Enable as suf-
3. Scan a bar code to select the symbology for which you wish to configure a custom Label
4. Determine the desired character(s) (you may choose up to three) which will represent the
5. Turn to the
6. Scan the ENTER/EXIT bar code to exit Label ID entry.
7. Scan the ENTER/EXIT bar code once again to exit Programming Mode.
This completes the steps to configure a Label ID for a given symbology.
Figure 9. Label ID Position Options
264
fix) by scanning the appropriate bar code in the section
Reference Figure 9 for Label ID positioning options if multiple identification features are
enabled.
ID from the section Label ID Symbology Selection, starting on page
Label ID for the selected symbology.
ASCII Chart
hex digits associated with your choice of Label ID. For example, if you wish to select an
equal sign (=) as a Label ID, the chart indicates its associated hex characters as 3D. Turn to
Keypad, starting on page 297
determined. For the example given, the characters '3' and 'D' would be scanned. More
examples of Label ID settings are provided in
If you make a mistake before the last character, scan the CANCEL bar code
to abort and not save the entry string. You can then start again at the begin-
ning.
NOTE
Prefix Label ID Aim ID
on the inside back cover of this manual and find the equivalent
and scan the bar codes representing the hex characters
Table
Bar Code Data Label ID
OR
Label ID Control on page
72.
18.
Suffix
TM
QuickScan Lite QW2100
71.