Customizing Configuration Settings
Customizing Configuration Settings
Configure Interface Settings
If after scanning the interface bar code from the previous table, your installation requires you to
select options to further customize your reader, turn to the appropriate section for your interface
type in
•
•
•
•
•
•
Global Interface Features
See "
Global Interface Features" on page 39
Configuring Other Features
If your installation requires different programming than the standard factory default settings,
the following sections of this manual allow configuration of non-interface-specific settings you
might require:
Reading Parameters
indicators and other universal settings.
1D Symbologies
settings allow you to enable/disable symbologies, set label lengths, require check digit, etc.
WIRELESS FEATURES
Software Version Transmission
The software version of the device can be transmitted over the RS-232 and Keyboard interfaces
by scanning the following label.
Product Reference Guide
"Configuration Parameters" starting on page 37
"RS-232 Only Interface" on page 41
"RS-232/USB-Com Interfaces" on page 46
"Keyboard Settings" on page 55
"RS-232/USB-Com Interfaces" on page 46
"IBM 46XX Interface" on page 67
"Wand Emulation Interface" on page 71
:
Reading Parameters include programming for scanning, beeper and LED
:
Includes options concerning the bar code label types (symbologies). These
: Contains programming options for RF, STAR and Bluetooth models only.
RevA
.
for settings configurable by all interface types.
Transmit Software Version
Setup
33