5 Operation
This section describes how to operate the CP2210 projector.
5.1
Turn the Projector On
WARNING
specified voltage range.
1. Ensure the circuit breaker for the projector is ON.
2. On the Touch Panel Controller (TPC), tap and hold the green power
3. On the TPC, tap and hold the light bulb
5.2
Turn the Projector Off
1. On the Touch Panel Controller (TPC), tap and hold the light bulb
2. On the TPC, tap and hold the red power
and electronics stay on for 10 minutes. After this cool down period, the projector enters standby mode.
3. If you are servicing the projector, or removing the protective cover, disconnect AC and turn the breaker
OFF.
CP2210 User Manual
020-100410-07 Rev. 1 (01-2012)
DO NOT attempt to turn the projector on if the AC supply is not within the
icon to ignite the lamp.
icon. The projector enters a cool down mode and the fans
icon.
icon to turn the lamp off.
5-1