Work With The Lamp; Adjust Lamp Power; Change The Lamp Power Percentage; Use Lamploc To Adjust The Lamp Position - Christie CP 2210 User Manual

5.5

Work with the Lamp

This section provides information and procedures for optimizing lamp performance. Optimizing lamp
performance can ensure you receive the brightest, most uniform image possible for the life of the lamp.

5.5.1 Adjust Lamp Power

1. Tap Menu > Advanced Setup > Lamp Power/LiteLOC Setup
2. Increase or decrease the Power % value.
3. Tap Set Target.
4. Select Enable LiteLOC™.

5.5.2 Change the Lamp Power Percentage

Entering a new Lamp Power percentage temporarily disables LiteLOC settings.
1. Tap Menu > Advanced Setup > Lamp Power/LiteLOC Setup.
2. Increase or decrease the Power % value.
5.5.3 Use LampLOC
To ensure optimal lamp performance and peak brightness at the screen for the life of the lamp, use LampLOC
to adjust the lamp position when you install a new lamp in the projector. After making the adjustment , the
lamp is well-centered and distanced correctly from the remainder of the illumination system. Before adjusting
LampLOC , ensure the following criteria are met:
™
• The lamp must be ON and the douser (shutter) OPEN during adjustment. A 10-minute warm-up is recom-
mended. Ensure to follow all the criteria specified in
• Perform a white test pattern. This is recommended to allow you to view LampLOC
To automatically adjust LampLOC
1. Tap Menu > Advanced Setup > LampLOC™ Setup.
2. Tap Do Auto.

5.5.4 Manually Adjust the Lamp Position

1. On the Main screen of the TPC, tap the test patterns button.
2. Tap RGB-12bit-Full Screen White.
3. Mount a light meter on a tripod and center it with the lens. The distance from the lens does not matter. You
may need an attenuator or an internal foil aperture.
4. Tap Menu > Advanced Setup > LampLOC™ Setup.
5. Tap the directional arrows to adjust the value displayed in the Z field. The brightness reading in front of
the lens should be maximized.
6. Tap the directional arrows to adjust the values displayed in the X and Y fields. The brightness reading in
front of the lens should be maximized.
7. Repeat Steps 5-6, but take your readings at the screen instead of at the lens.
CP2210 User Manual
020-100410-07 Rev. 1 (01-2012)
™ to Adjust the Lamp Position
:
™
.
5.1 Turn the Projector On, on page
Section 3: Operation
™
5-1.
progress on-screen.
™
5-3