Lens Setup Window - Christie CP 2210 User Manual

Section 6: Projector Menus

6.14.5 Lens Setup Window

Use the Lens Setup window to setup the primary and auxiliary lenses and configure the Intelligent Lens
System (ILS) if it is installed. Tap Menu > Advanced Setup > Lamp Power/LiteLOC™ Setup.
2
Table 6.17 Lens Setup Window
Control
Primary Lens
Serial Number
Auxiliary Lens
Serial Number
Save
Revert
Enable
Automatic ILS
Reset on Startup
Quick Reset
Full
Calibration
MALM Installed
MALM Reset
6-30
1
Figure 6-23 Lens Setup Window
Description
The type of primary lens installed on the projector.
The serial number for the primary lens.
The type of auxiliary lens installed on the projector.
The serial number for the auxiliary lens.
Saves the lens type or serial number(s).
Reverts to the last saved values for the lens type or serial number(s).
Automatically moves the lens to the position specified by the channel and overwrites focus, zoom, and
offset settings in the ILS file.
Uses ILS settings to calibrate the lens when you start the projector.
Resets the ILS and returns the lens to the manual position..
Perform a full ILS calibration and returns the lens to the manual position.
Indicates a MALM is installed on the projector.
Resets the position of the MALM to the mechanical reference point.
3
CP2210 User Manual
020-100410-07 Rev. 1 (01-2012)