Lamploc™ Setup Window - Christie CP 2210 User Manual

Section 6: Projector Menus
6.14.3 LampLOC™ Setup Window
Use the LampLOC Setup window to reposition the projector bulb for optimized light output. Tap Menu >
Advanced Setup > LampLOC™ Setup
Click Do Auto to run LampLOC automatically. You must turn the lamp on before you run LampLOC. If you
turn the lamp off during LampLOC, the bulb returns to its former position. The douser is open and it is not
functional during a LampLOC adjustment. To keep the bulb optimized as it ages, run LampLOC once a month
Table 6.15 Advanced Setup: LampLOC
Control
Left/Right
Up/Down
In/Out Arrow
Buttons
Value
Light Bar
Do Auto
Display Full Screen White
Test Pattern
6-28
1
3
Figure 6-21 LampLOC™ Setup Window
Setup Window
™
Description
Moves the lamp up, down, in, out, left, and right. The current position of the lamp displays in
Cartesian coordinates. Tap once to increase or decrease the lamp position by a single
increment. Press and hold a button to increase or decrease the lamp position by multiple
increments. You cannot move the lamp beyond the pre-defined limits for the projector. For
CP2210, X/Y = +/-250; Z = +/-175.
Shows the current light sensor reading in arbitrary units-of -measure and does not represent
actual lumens or fL.
Indicates the current light intensity (vertical bar) and LiteLOC
Starts the auto LampLOC
highest light reading is obtained from the light sensor.
Temporarily displays a full screen white test pattern for the duration of the LampLOC™
adjustment. The previous display reappears when you close the LampLOC™ Setup page or
clear the check box.
™ calibration procedure, which adjusts the lamp position until the
2
LiteLOC™
Target
Light
Intensity
target (red horizontal line).
™
CP2210 User Manual
020-100410-07 Rev. 1 (01-2012)
.