Rotate The Lamp - Christie CP 2210 User Manual

Section 7: Maintenance
11. Software Adjustments. In the Advanced Setup: Lamp
History window, tap the Add Lamp button and record lamp
type, serial number, reason for change and number of the
hours logged on to the lamp. If the lamp has not been
previously used, enter 0. Tap Save to save the data entered
(Figure 7-3).
12. Power the Lamp ON. Tap
to turn the lamp ON.
13. Adjust LampLOC
(LampLOC
window. By adjusting lamp position, you can achieve
optimized light output by centering the lamp with the
reflector and obtaining correct distancing from the center of the illumination system.
7.9

Rotate the Lamp

DANGER
EXPLOSION HAZARD! Wear authorized protective clothing whenever the lamp door is open
and when handling the lamp. Never twist or bend the quartz lamp body. Use the correct
wattage lamp supplied by Christie. 3) Ensure those within the vicinity of the projector are also
wearing protective safety clothing. 4) Never attempt to remove the lamp when it is hot. The
lamp is under pressure when hot and may explode, causing personal injury, death, or property
damage. Allow the lamp to cool completely.
When the operational life of the lamp reaches halfway it is recommended that you rotate it 180° to ensure an
even burn of the lamp, improve lamp performance and extend the life of the lamp. An alarm window appears
on the TPC after you complete the lamp rotation.
1. Tap and hold the red power button
2. Allow the lamp to cool for a minimum of 10 minutes.
3. Unplug the projector.
4. Put on your protective clothing and face shield.
5. Unlock and open the lamp door. Release the tethered latch mechanism to remove the door entirely.
6. Remove the cathode cable and rotate the lamp 180°.
7. Replace the cathode cable.
8. Replace and lock the lamp door.
9. Remove your protective clothing and face shield.
10. Tap and hold the green power button to turn the projector on.
11. Tap Menu > Advanced Setup > Lamp History.
12. Tap Acknowledge Lamp Rotation.
7-6
from the TPC Main panel
. Immediately adjust lamp position
™
) via Advanced Setup: LampLOC™ Setup
™
1) Lamp rotation must be performed by a qualified service technician only. 2)
on the TPC Main panel to turn the lamp and projector off.
Figure 7-3 Add Lamp Window
CP2210 User Manual
020-100410-07 Rev. 1 (01-2012)