Connect Power - Christie CP 2210 User Manual

Section 2: Installation and Setup
1. If the projector is operating, turn it off and allow it to cool a minimum of 10 minutes.
2. Turn the breaker switch for the projector off.
3. Disconnect the projector from AC power.
4. Put on your protective clothing and face shield.
5. Using the security key provided, open the rear door to access the projector components. The door
mechanism includes a safety interlock switch, which turns lamp power OFF and prevents it from being
turned ON when the door is open. The interlock wiring connects directly to the ballast.
6. Turn the 2 thumbscrews on the internal lamp door counterclockwise.
7. Install the lamp. See
Table 2.1 Lamp Types Available for CP2210
Lamp
1.4kW
1.8kW
2.0kW

2.12 Connect Power

WARNING
• DO NOT attempt operation if the AC supply and cord are
not within the specified voltage and power range. See
Section 6 Specifications.
• Always power down the projector before unplugging the
AC line cord. The appropriate ratings for the projector are
listed on the license label (located on the back of the pro-
jector). Wait 15 minutes for the main exhaust fan to turn
OFF and for the lamp to cool sufficiently before unplug-
ging the projector.
• A certified electrician is required. Ground (earth) connec-
tion is necessary for safety. Never compromise safety by
returning the current through the ground. Connect
ground FIRST to reduce shock hazard from high leakage.
NOTICE: Use the line cord provided with each projector. DO NOT compromise safety by using other
connectors. For all other regions, ensure a line cord, power plug and socket that meet the appropriate rating
standards are used. For more information, refer to 5.1 Turn the Projector On.
2-10
7.8 Replace the Lamp
Type
CXL-14M
CDXL-18SD
CDXL-20SD
for lamp installation instructions.
Figure 2-9 AC Receptacle
CP2210 User Manual
020-100410-07 Rev. 1 (01-2012)