Christie CP 2210 User Manual page 143

Change the power state of the projector. Data can be:
3 - Power OFF - all electronics power OFF except Projector Control Module (PCM). It's also called Standby mode.
1 - Power ON - projector is powered ON with lamp ON.
0 - Full power mode - projector is ready for lamp ON.
11 - Warm up. Read only, its middle status between standby and full power mode.
10 - Cool down. Read only, projector will stay in cooling down mode for 15 minute after lamp is turned OFF.
SUBCODE DESCRIPTION OF USE
Status of current cooling down timer. Read only command.
COOL
Select power state.
NONE
Status of current power state. Read only command.
STAT
EXAMPLES:
(PWR+STAT?) - Get projector power status
(PWR+COOL?) - Get how many seconds left on cooling down mode
(PWR3) - Set the projector to standby mode
(PWR0) - Turn the projector ON and lamp OFF
(PWR1) - Turn the projector ON and lamp ON
(PWR?) - Get the target power state from the latest command sent to the projector. Target power state.
For projector power states, refer to
Remote Access Level (RAL)
Set the remote serial protocol access level for a serial communications port.
0 - No Access,
1 - Login Required,
2 - Free Access.
Default value is 1 - Login required.
SUBCODE DESCRIPTION OF USE
Set the access level on Ethernet all ports.
NONE
Set the access level on RS232 port A.
PRTA
EXAMPLES:
(RAL 0) Disable remote serial protocol access for all Ethernet ports
(RAL?) Get access level for Ethernet ports (RAL!0)
(RAL+PRTA 2) Set remote serial protocol access level on port A to free access
(RAL+PRTA?) Get access level (RAL+PRTA!2)
Reboot TPC (RBT)
Command for rebooting the TPC, requires argument 3.
SUBCODE DESCRIPTION OF USE
Reboot TPC, use 3 as argument other arguments have no effect.
NONE
Screen Format (SCF)
elect Screen format file which describes the geometry for the output image.
S
SUBCODE DESCRIPTION OF USE
Replace xxx with the channel number. Valid range is 101 - 164.
Cxxx
Select screen file for the current channel.
NONE
CP2210 User Manual
020-100410-07 Rev. 1 (01-2012)
5.3 Projector Power States, on page 5-2
Appendix A: Serial API Commands
.
Valid sections are
A-17