Christie CP 2210 User Manual page 57

Control
4: Power
Power OFF
5: Lamp
Lamp OFF
6: Douser
Douser Closed
7: Aux Lens
Aux Lens OUT
8: Lens Adjust
9: Test Patterns
Disable
10: Operational Status
CP2210 User Manual
020-100410-07 Rev. 1 (01-2012)
Description
Turns the projector on or off. Press off to place the projector in stand-by mode.
To prevent accidental activation, you must press and hold the on or off buttons.
Power ON
A message displays in the title bar when the projector turns on or off.
Turns the lamp on or off. To prevent accidental activation, you must press and
hold the on or off buttons. A boot delay occurs if you select lamp on before
Lamp ON
pressing power on.
Opens or closes the douser.
Douser Opened
Engages or disengages the auxiliary lens. If the auxiliary lens mount is not
installed, the Aux Lens buttons are disabled. Engaging the auxiliary lens
Aux Lens IN
temporarily overrides the position settings defined in the Config 1 channel.
Controls the Intelligent Lens System (ILS) lens motors. Press to open the ILS
Adjust window. If the Intelligent Lens System is not installed, the Lens Adjust
button is not available.
Selects or disables test patterns. Press Select Test Pattern to open the Preferred
Test Patterns window.
Select Test Pattern
Displays the status of projector functions including the Projector Intelligence
Board (PIB), TI Electronics the Integrated Cinema Processor Board (ICP), Link
Decrypter (LD), Internal Media Block (IMB), Standby Power, Main Power, Run,
and Marriage. A green LED indicates the system is functioning correctly. A red
LED indicates a critical error that you must correct. Click the status LED to open
the Status window and resolve issues.
Section 6: Projector Menus
6-3