C O N F I G U R I N G T H E P R I N T E R
This chapter explains how to configure the printer to use the
verifier. You can set the state, scan beam, mode, clear data, print
a summary label, and detect the cable.
Note:
Make sure the printer and verifier are connected with the
communications cable.
State
Scan
Beam
The options are listed in the following table.
Option
State
Scan Beam
Mode
Clear Data
Print Summary
Cable Detect
MAIN MENU
Setup
Verifier
Mode
Clear
Data
Choices
Enabled/Disabled
Off When Idle/Always On
Def 2/Def 19
Yes/No
Yes/No
None/I-O/I-O & Data
Cable
Print
Detect
Summary
Default
Disabled
Off When Idle
Def 2
No
No
I-O & Data
Configuring the Printer 5-1
5