Troubleshooting; Configuring A Wireless Printer Using A Wired Connection - Avery Dennison Monarch Tabletop Printer 1 System Administrator Manual

T R O U B L E S H O O T I N G
This chapter includes troubleshooting information for network setup, adjusting the
printer to remove ribbon wrinkle, and setting the ribbon's tension.
For more information about using MonarchNet2™ to configure the printer, refer to the
MonarchNet2 Operating Instructions.
C o n f i g u r i n g a W i r e l e s s P r i n t e r u s i n g a W i r e d C o n n e c t i o n
Depending on the facility's network, you may need to use a wired connection to initially
configure the wireless printer.
Note: The ADTP1 printer has different IP addresses based on connection type: one for
wired (Ethernet) and a different one for wireless connections.
The 169.x.x.x IP address is a default address. If this IP address appears on your
printer, it indicates the DHCP request failed.
Connect an ethernet cable to the printer.
1.
Turn on the printer. Once the printer connects to the wired network, you see its IP
2.
address on the display.
Start your Web browser.
3.
4. Type in your printer's IP address and press Enter.
Click Log In.
5.
Type access for the password and click Submit.
6.
1 1

Troubleshooting 11-1