Installing The Wall Mount; Mounting Instructions - Mobotix Q24M User Manual

88
/164
Direct installation
over on-wall and flush-
mounted wall outlets
Q24M Camera Manual: Installation
2.8

Installing The Wall Mount

2.8.1 Mounting Instructions

The Wall Mount allows you to easily mount Q24M cameras to walls or extensions, both
indoors and outdoors. The camera remains IP65 weatherproof (dust-proof and resistant
to water jets). The Wall Mount also covers RJ45 wall outlets and has ample space for
additional modules (WLAN, batteries, etc.).
Before mounting the MOBOTIX Q24M with the Wall Mount, you must prepare the network
connection and drill the holes for the fixtures:
• The on-site network cabling is passed through the opening
in the back of the wall mount. The cable and the required
(standard) connector for the camera cable (patch cable) are
ideally protected by a robust wall sealing made from foam
rubber. Nothing is visible or accessible from the outside.
The Wall Mount may be mounted directly on top of flush
or protruding wall outlets. Maximum width x height of the
outlet: 88 mm x 80 mm.
• Only use the Q24M factory installed patch cable (50 cm cable length) or a MOBOTIX
cable of different length available from the range of accessories.
• All openings of the camera housing need to be closed off properly. This is the only
way to guarantee that the camera remains weatherproof.
• The included screw anchors should be used for the drill holes in the wall. Use
the supplied drilling template for the Q24M Wall Mount (fold-out at the end of this
manual) to mark the position for drilling the holes and the holes through which the
cables will later be fed.
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • sales@mobotix.com