Swingarm Installation - Honda CRF450X 2005 Service Manual

- - -- - - - _
..
-
REAR WHEEL/SUSPENSION
15-40
Apply grease t o the th rust needle bearing rolling
area and dust seal lips.
Install the following:
- Washers
- Th rust needle bearings
- Pivot collars
- Dust seals
- Side collars
Install the chain slider so its hole fits over the tab on
the swingarm.
Clean and apply locking agent t o the screw threads.
Inst all and tighten the screws to the specified
torque.
TORQUE: 4.2 N'm (0.4 kgf·m, 3.1 Ibf.ft)
INSTALLATION
Apply thin coat of grease to the swingarm pivot bolt
sliding surface.
Install the swingarm onto the frame.
Install the swingarm pivot bolt through the frame
and swingarm pivot.
f!
• un;..
DUST
SEALS
1.5 - 2.0 mm
(0.06 - 0.08 in)
THRUST NEEDLE BEARING
~~ -.~
WASHERS
CHAIN >LIL'tH
"
II!il3
SCREWS
•