Honda CRF450X 2005 Service Manual page 377

(
Apply mUlti-pu rpose grease NLGI No.2 (molybde-
num disulfide additive) to the dust sea l lips, side
coliar seating surface and needle bearing rolling
area.
Install the dust seals, pivot collar and side collars .
• Make sure the needle bearing rollers afe in posi-
tion before installing.
Number of needle rollers: 32
REAR WHEEL/SUSPENSION
PIVOT COLLAR •
Apply oil to the shock arm and shock link nut
~;~~~~~~~~j
threads and flange surface.
Loosely install the following;
- Shock link
Shock link bolt/nut/washer (frame side)
- Shock arm
- Shock arm bolt/nut/washer (swingarm side)
NOTE:
After '07; Align t he flat surfaces of the shock arm
bolt and swingarm.
- Shock arm bolt/nut/washer (shock l ink side)
Install the shock absorber lower mounting bolt
aligning the flat side of the bolt with the stopper on
the shock absorber.
Tighten all nuts to the specified torque.
TORQUE:
Shock link nut (frame side):
53 N·m (5.4 kgf·m , 39 Ibf.ft)
Shock ann nut (swingann side):
53 N,m (5.4 kgf·m , 39 Ibf.ft)
Shock arm nut (shock link side):
53 N·m (5.4 kgf·m , 39 Ibf.ftl
Shock absorber low er mounting nut:
44 N·m (4.5 kgf·m , 32 Ibf.ft)
-
15-35