Honda CRF450X 2005 Service Manual page 301

Rep/Bee the wheel
bean"ngs in pairs.
Do
not reuse
old
bearings.
FRONT WHEEL/SUSPENSION/STEERING
Torque the front spokes in two or three progressive
steps
TOOL:
Spoke wrench. 6.1 mm
07JMA·MR60100
or
07701·0020300
(6.1 mml or equiv-
alent commer·
dally available in
U,S.A.
TORQUE: 3.68 N 'm (0.4 kgf-m, 2.7 Ibf.ft)
Install the front rim lock, sening rubber. tube and
tire.
Tighten the front rim lock to the specified torque.
TORQUE: 12 N 'm (1 .2 kgf·m , 9lbf.ftj
Pack all bearing cavities with grease.
Drive the left wheet bearing in the wheel hub until it
is fully seated using special tools .
• Install the wheel bearings with the sealed sides
toward the outside.
TOOLS:
Driller
Attachment, 37 x 40 mm
Pilot. 20 mm
07749·0010000
07746·0010200
07746--0040500
Install the distance col la r i nto place, then drive the
right w heel bear ing using the same speCial tools.
Install the brake disc onto the wheel hub with the
drive mark facing out.
Install the brake disc bolts and nuts.
Tighten the nuts 10 the speCified torque.
TORQUE: 16 N 'm 11 .6 kgf·m , 12 IbUtl
Pack a new left dust seal lip with grease and install it
into the hub.
14-11