Starter Relay Switch Removal/Installation; Power Input Line; Operation Check - Honda CRF450X 2005 Service Manual

ELECTRIC STARTER
19-14
POWER INPUT liNE
Connect the starter relay switch 4P connector.
Shift the transmission into neutral.
Pull the clutch lever fully, and push the starter
switch.
Measure the voltage between the Yellow/red wire
terminal
(+)
and ground H.
If the battery voltage appears only when the clutch
lever is pu lled fully and starter switch is pushed, the
circuit is normal.
OPERATION CHECK
Remove the starter relay switch (page 19-14),
Connect a fully charged 12 V battery positive wire to
the relay switch Yellow/red wire terminal and the
negative wire to the Green wire terminal.
There should be continuity between the cable termi-
nals when the battery is connected, and not con t inu-
ity when the battery is disconnected.
REMOVAL/INSTALLA TION
Remove the left side cover (page 3-3).
Disconnect the starter relay switch 4P connector .
Pull out the starter relay switch from the rear fender.
Remove the bolts and disconnect the starter motor
and battery positive (+) cables.
Installation is in the reverse order of removal.
•