Table of Contents
Advertisement
18
Changing the System Settings
To change the system settings on the OIT:
1. Open the Setup Toolbar as described above, and click the System Settings icon.
2. A dialog will be displayed requesting the Local password. The default password is 111111.
3. Once the correct password has been entered, the System Settings dialog is displayed. For all
tabs, the Cancel, Apply, and OK buttons are available.
Cancel
Apply
OK
4. Click on the Network tab to configure network settings. The Network dialog is displayed.
5. The Network tab allows configuration of the IP settings. The default setting is Auto Get IP
Address. Use this setting if the OIT will provide an IP address by a DHCP server. If
connected to a DHCP server, this dialog will display the IP settings obtained by the OIT. The
IP fields are disabled, and are not editable.
6. If using a static IP address, use the IP Address Get From Below option. The IP fields are
enabled. Enter the appropriate settings for your network.
1010-1007W, Rev 06
You may have to move windows around a bit to gain access to the virtual keyboard.
You may also have to click inside the password field again.
Close the System Settings dialog without saving any changes.
Save the current settings without closing the System Settings dialog.
Save the current settings and close the System Settings dialog.
Sil ver Se ries In stal la tion & Op er a tion Man ual
Advertisement
Table of Contents
