Cre At Ing A Sam Ple Pro Ject; Set Ting The Sys Tem Pa Ram E Ters - Maple Systems Silver Series Installation And Operation Manual

36
The following illustration shows the various sections of EasyBuilder.
Draw Toolbar

Cre at ing a Sam ple Pro ject

This section walks you through the creation of an EasyBuilder project named MTPrj1. Once downloaded to the
OIT, this basic configuration allows the OIT to connect to the PLC, display a startup screen, and display a screen
containing one PLC register monitor when a switch on the startup screen is pressed.
Although we strongly recommend that you perform the following steps to create this sample project, the project is
already included in your EasyBuilder software with the following filenames:
HMI5056.MTP-sample project for the HMI5056
HMI5070.MTP-sample project for the HMI5070
HMI5080.MTP-sample project for the HMI5080
HMI5104.MTP-sample project for the HMI5104
HMI5121.MTP-sample project for the HMI5121
HMI5150.MTP-sample project for the HMI5150

Set ting the Sys tem Pa ram e ters

Whenever you begin a new project, you should always set the system parameters before you create any windows.
System parameters determine the basic operating conditions of the OIT such as what type of PLC it is connecting to.
To edit the System Parameters
1. Click the Edit menu on the main screen of EasyBuilder.
1010-1007W, Rev 06
Manager toolbar
Sil ver Se ries In stal la tion & Op er a tion Man ual
Part1toolbar
Work area
Part2 toolbar