Table of Contents
Advertisement
14
2. Set the OIT in the panel cutout and hold it in place until all clamps are in position.
3. Tighten the screw clamps until all are uniformly snug.
CAUTION: Do not over-tighten the screws beyond snugness, or you may damage the housing, or cause the
touchscreen to malfunction.
REINSTALLATION: Because the gasket will take a "set" to the panel, be sure to reinstall the OIT to the same
panel cutout when a NEMA 4 seal is required. For best results, also replace the gasket itself.
1010-1007W, Rev 06
Sil ver Se ries In stal la tion & Op er a tion Man ual
Advertisement
Table of Contents
