Table of Contents
Advertisement
In stal la tion of OITs
Mount the OIT to the Panel
Ends of screws must not
protrude from the clamp
Screw clamp locking
tabs go through the
slots
STEPS:
1. Prepare the screw clamps for the OIT by positioning the metal brackets at the midpoints of the screws.
Position the screws so that the ends don't protrude from the plastic portions.
Panel
Hold the OIT against
the panel until all screw
clamps are in position
Screw Clamp Placement
In stall ing Screws on the OIT
Position 4 screw clamps
(2 each side)
Position screw clamps 6 places in slots provided:
2 screw clamps each side and one top and bottom
Side View
Tighten all screw clamps until
they are uniformly snug
Panel
Clamps Tightened
Panel
Panel
1010-1007W, Rev 06
13
Advertisement
Table of Contents
