Con Fig U Ra Tion Wir Ing; Con Nect The Oit To The Pc For Con Fig U Ra Tion - Maple Systems Silver Series Installation And Operation Manual

Operator interface terminal
Hide thumbs Also See for Silver Series:
Table of Contents

Advertisement

15

Con fig u ra tion Wir ing

The OIT must be configured for a particular protocol before use. The EZware software is used for configuring the
OIT. For detailed instructions on installing and using the software, please refer to the software documentation
section of this manual.

Con nect the OIT to the PC for Con fig u ra tion

To configure the OIT using Maple System's configuration software, you will need either an Ethernet crossover
cable, Maple P/N 7431-0104 or a USB download cable, Maple P/N 7431-0115 depending upon the OIT model used.
If using a switch or router between the PC and the OIT, use a straight-through or crossover cable as required by the
switch or router.
1010-1007W, Rev 06
If an Ethernet port is not available on the PC, you may be able to install a USB
Ethernet adapter. You can also transfer the project to the OIT with a Compact Flash or
USB memory device. Refer to Chapter 2, OIT Local Setup.
Sil ver Se ries In stal la tion & Op er a tion Man ual

Advertisement

Table of Contents
loading

Related Products for Maple Systems Silver Series

This manual is also suitable for:

Hm15070thHm15100t

Table of Contents