Table of Contents
Advertisement
221
X axis w/reverse
No. of states:
scaling
Input low:
Input high:
Scaling low:
Scaling high:
Y axis w/reverse
No. of states:
scaling
Input low:
Input high:
Scaling low:
Scaling high:
5. Refer to the Bit Lamp Object section for information on using the Shape tab.
6. Refer to the Bit Lamp Object section for information on using the Label tab.
7. Click OK. The Create Moving Shape Object form closes and the main screen of EasyBuilder
appears with the cursor tied to a rectangular outline of the part you just created at the upper
left corner of the screen. Move the part to the desired location on the window.
8. Once the part is placed onto the window, you can adjust the location of the label inside the
part by clicking once on the label. This will highlight the entire object. Click on the label
again. Now only the label is highlighted, allowing you to move it without moving the part.
Note: if you double-click (click twice rapidly) then you will not highlight the label but rather
enter the Moving Shape Object's Attribute dialog box.
1010-1007W, Rev 06
Reads two 16-bit registers. Register #1 determines the state of the shape displayed.
Register #2 determines the position of the shape along the X axis. The OIT places the
shape relative to the starting location using scaling to calculate position. For example, if
Input low=0, Input high=10, Scaling low=0, and Scaling high=100, then when the value
in the PLC register increases by 1, the shape moves left along the X axis by 10 pixels.
Range = 0 to 255
This is the lowest raw data value that is in the PLC data register
This is the highest raw data value that is in the PLC data register
This is the low scaled value.
This is the high scaled value.
Reads two 16-bit registers. Register #1 determines the state of the shape displayed.
Register #2 determines the position of the shape along the Y axis. The OIT places the
shape relative to the starting location using scaling to calculate position. For example, if
Input low=0, Input high=10, Scaling low=0, and Scaling high=100, then when the value
in the PLC register increases by 1, the shape moves up along the Y axis by 10 pixels.
Range = 0 to 255
This is the lowest raw data value that is in the PLC data register
This is the highest raw data value that is in the PLC data register
This is the low scaled value.
This is the high scaled value.
Sil ver Se ries In stal la tion & Op er a tion Man ual
Advertisement
Table of Contents
