Charging With Onboard Charger - Club Car Onward Operator's Manual

NOTICE
5. Connect the DC cord to the vehicle charger receptacle (1).
Note: The vehicle will start to charge in 10 seconds or less.
When the vehicle starts to charge:
• ON CHG will show on the dash display.
• The multi-purpose buzzer will operate.
• If equipped, the headlights will flash.
Note: When the battery is fully charged, CHARGD will show on the dash display.
DANGER
6. Before vehicle operation, disconnect the DC cord from the vehicle charger receptacle.

CHARGING WITH ONBOARD CHARGER

DANGER
WARNING
The recommended temperature range to charge the battery is from -4°F (-20°C) to 113°F (45°C).
To charge with an onboard charger:
1. Turn the key to OFF.
ONWARD HP 4-PASSENGER LITHIUM-ION
Operators Manual
TPCC01DL00EN019 (Edition A)
INCORRECT REMOVAL AND INSTALLATION OF THE DC CORD CAN
CAUSE DC CORD DAMAGE AND VEHICLE CHARGER RECEPTACLE
DAMAGE. DO NOT TWIST, BEND, OR MOVE THE DC CORD PLUG
SIDE TO SIDE. DO NOT PULL ON THE DC CORD. HOLD THE PLUG
HANDLE AND PUSH THE PLUG STRAIGHT INTO THE VEHICLE
CHARGER RECEPTACLE.
IF THE DC CORD IS REMOVED TOO FAST, ARCING AND BURNING
CAN CAUSE DAMAGE TO THE PLUG, RECEPTACLE, AND CAUSE THE
BATTERIES TO EXPLODE. REMOVE THE DC CORD SLOW.
CHARGING THE BATTERIES WITH ACCESSORIES ON CAN CAUSE
A FIRE AND SERIOUS PERSONAL INJURY. TURN OFF ALL
ACCESSORIES BEFORE CHARGING THE BATTERIES.
LOOSE CORD CONNECTIONS CAN CAUSE A FIRE. MAKE SURE
THAT ALL CORD CONNECTIONS AT THE RECEPTACLE ARE CLEAN
AND TIGHT.
Battery Maintenance
Battery Charging
Page 73
9