Side Stand/Ignition Interlock System Parts Inspection - Suzuki GSX-R1000 Service Manual

Measure the relay coil resistance between the terminals using
the multi circuit tester. If the resistance is not within the specified
value, replace the starter relay with a new one.
ITUt! 09900-25008: Multi circuit tester set
_ Starter relay resistance: 3 - 5
n
SIDE STAND/IGNITION INTERLOCK SYSTEM
PARTS INSPECTION
Check the interlock system for proper operation. If the interlock
system does not operate properly, check each component for
damage or abnormalities. If any abnormality is found, replace
the component with a new one.
SIDE-STAND SWITCH
The side-stand switch coupler is located above the crankcase.
• Lift the fuel tank. (c:::::T'5-5)
• Disconnect the side-stand switch coupler and measure the
voltage between Green and BlacklWhite lead wires.
nUt! 09900-25008: Multi circuit tester set
~ Tester knob indication: Diode test (.,..)
-------------
Green BlacklWhite
(cB
Probe)
(8
Probe)
ON
0.4 - 0.6 V
(Side-stand up)
OFF 1.4 V and more
(Side-stand down) (Tester's battery voltage)
NOTE:
If
the tester reads 1.4 V and below when the tester probes are
not connected, replace its battery.
ELECTRICAL SYSTEM 9-15