Suzuki GSX-R1000 Service Manual page 360

8·74 CHASSIS
DRIVE CHAIN
Use the special tool in the following procedures, to cut and rejoin
the drive chain.
,ggt!
09922-22711: Drive chain cutting and joining tool set
NOTE:
When using the special tool, apply
a small quantity of grease to
the threaded parts of the special tool.
DRIVE CHAIN CUTTING
• Set up the special tool as shown in the illustration.
CD
Tool body
ell
Grip handle
®
Pressure bolt "A"
@ Pressure bolt "B"
@ Bar
@ Adjuster bolt (with through hole)
({) Pin remover
@ Chain holder (engraved mark 500)
with reamer bolt M5 x 10
NOTE:
The tip of pin remover ({) should be positioned inside approxi-
mately
5 mm (0.2 in) from the end face of pressure bolt
'~"®
as
shown in the illustration.
5 mm (0.2 in)