Suzuki GSX-R1000 Service Manual page 128

• Set the crankshaft to the conrods and upper crankcase.
• Apply MOLYBDENUM OIL SOLUTION to the crank pin and
bearing surface.
1r
MOLYBDENUM OIL SOLUTION
I
CAUTION
I
I
Be sure to clean the conrod big end.
• When fitting the conrod cap, make sure that I.D. code
®
on
each conrod faces intake valve side.
• Apply engine oil to the bearing cap bolts.
• Tighten the bearing cap bolt by using a 12 mm, 12 point
socket wrench in the following two steps.
~ Conrod bearing cap bolt:
Initial: 21 N·m (2.1 kgf-m, 15.5 Ib-ft)
Final : 90
0
(1/4 turn)
• Apply engine oil to the conrod big end side surfaces.
• Check the conrod movement for smooth turning.
• Apply MOLYBDENUM OIL SOLUTION to each crankshaft
journal bearing lightly.
1r
MOLYBDENUM OIL SOLUTION
ENGINE 3-75