Suzuki GSX-R1000 Service Manual page 260

4th step:
To set the EXCV to fully open position, apply 12 volts to
®
and
@ terminals.
Positive wire - @ (Gray wire) terminal
Negative wire -
®
(Pink wire) terminal
!CAUTION!
To prevent the motor damage, stop applying 12 V as
soon as the EXCV reaches fully open position.
Measure the position sensor output voltage at fully open posi-
tion.
_ Position sensor output voltage
EXCV is fully open: 3.7 ;;;;; output voltage;;;;; 4.5 V
(® Yellow -
8
White)
If the measured voltage is more than specification, adjust the
NO.2 cable adjuster as follows:
• Set the EXCVA to adjustment position. (c:::::r6-4)
I
CAUTION
I
Adjusting the NO.2 cable with the EXCV fully opened
can damage the EXCVA. Be sure to adjust the NO.2
cable with the EXCV set in adjustment position.
• Turn out the NO.2 cable adjuster
CD.
• Repeat the above procedure until the output voltage comes
within the specified value.
_ Position sensor output voltage
EXCV is fully open: 3.7
s;
output voltage;;;;;; 4.5 V
• After adjusting the EXCV cables, perform 1st step to confirm
C46 is not indicated.
EXHAUST SYSTEM 6·11