Usb Sp Settings - Ricoh B132 Service Manual

USB SP Settings

The following SP commands are available. But, only one setting can be adjusted,
and this must only be done if the customer has USB data transmission errors.
NOTE: Do not change the settings marked "DFU". These settings are for design
and factory use only.
To go into the SP mode:
1. Push 'Clear Modes'
2. On the operation panel keypad, input 107.
3. Hold down [Clear/Stop] () for more than 3 seconds.
4. Push "Copy SP" on the touch-panel to open the SP command selection screen.
SP Mode (Service)
Feed
SP1XXX
Drum
SP2XXX
Process
SP3XXX
Scanner
SP4XXX
Mode
SP5XXX
Periphs
SP6XXX
Data Log
SP7XXX
Data Log2
SP8XXX
5. Input 5844.
SP No. Name
5844 001 Transfer Rate
5844 002 Vendor ID
5844 003 Product ID
5844 004 Dev. Release Num
SM

Open All Close All Copy Window
COPY: SP1-001-001
Group
Page
Line
Line
Page
Group
Adjusts the USB transfer rate. Do not change the setting
unless there is a data transfer error with the USB high
speed mode.
HS/FS: High speed/Full speed auto adjust
(480Mbps/12Mbps)
FS: Full speed (12Mbps fixed)
Displays the vendor ID. DFU
Displays the product ID. DFU
Displays the development release version number. DFU
1-125
MFP CONTROLLER OPTIONS
14APR 2002 03:25
Exit
X-XXX-XXX
SP Direct
21
Initial 0
Prev Page Next Page
B064I999.WMF
Function
B132/B200