Ricoh B132 Service Manual page 403

Rev. 09/2005
Display
Download Error E22
22
Module ID
Card No xx/xx
⇒
SC991
23 Download Error E24
Power Off/On
30 No Valid Data E30
31 Reboot After Card
Insert E31
Module ID
Card No. xx/xx
32 Reboot After Card
Insert E32
Module ID
Card No. xx/xx
33 No Valid Data E33
34 No Valid Data E34
35 No Valid Data E35
36 No Valid Data E36
37 No Valid Data E37
40 Download Error E40
Module ID
Card No. xx/xx
41 Download Error E41
Module ID
Card No. xx/xx
SM
Details
System error 3 (+SC991)
Data fails to decompress. Card
defective.
System error 4
"Selfupdate" does not execute.
Software defective.
System error 5
Card read/write error. Software or card
defective.
Download dysfunction 1
Print download is not possible. Cannot
download to HDD because HDD not
installed or defective.
Download dysfunction 2
Download continuity error with more
than one card. The second or later
card is not compatible.
Download dysfunction 3
Download interrupted because card is
not correct, or power failure interrupted
download.
Download dysfunction 4
Card version error. Attempted to
download program using a card with
the wrong version number.
Download dysfunction 5
Specification error. DOM card set in
EXP machine, or vice versa.
Download dysfunction 6
Wrong model. The inserted card is for
another model.
Download dysfunction 7
Module error. The program that you
are attempting to download does not
exist on the machine, or the contact
points at the card and the machine slot
are not connected.
Download dysfunction 8
Edit option card error. You attempted
to employ a used card.
Download result failure 1
Engine download failure.
Download result failure 2
Fax download failure.
4-3
PROGRAM DOWNLOAD
Recovery
• Cycle the machine
off/on and re-try.
• Replace card
• Replace controller
board
• Cycle the machine
off/on and re-try
• Replace the controller
board
• Cycle the machine
off/on and re-try
• Replace the card
• Replace the controller
board
• HDD defective
• HDD harness
disconnected,
defective
• Set the correct cards
in the correct order
• Use the correct card
• If power failure
caused the failure,
remove the card and
insert another.
• Use the correct card
• Use the correct card
• Use the correct card
• Use the correct card,
inserted correctly
• Install a ROM DIMM if
none is installed
• Use an unused card
• Cycle the machine
off/on and re-try
• Cycle the machine
off/on and re-try
B132/B200