Initializing Developer And Toner - Ricoh B132 Service Manual

Rev. 07/2005

Initializing Developer and Toner

1. At the left rear corner of the machine, make
sure that the manual breaker switch [A] is
UP.
Important: When the breaker switch is UP,
the copier is ready to be turned ON. The "|"
mark can be seen.
⇒
Important: Before you turn the copier ON,
make sure that you test the Electrical
Breaker Switch. (! 4.4 ELECTRICAL
BREAKER SWITCH TEST)
Important: Before you turn the copier ON,
make sure that the ARDF [B] is connected
to the copier at the left rear corner.
2. Connect the power cord of the copier to a
power outlet.
3. Open the front door [C].
Important!
• T
ON
URN THE MACHINE WITH THE FRONT
DOOR OPEN TO PREVENT THE MACHINE
FROM PERFORMING THE INITIAL PROCESS
CONTROL SELF
• I
F THE FRONT DOOR IS NOT OPEN
DRUMS WILL TURN WITH NO TONER IN THE
PCU .
S
• I
F THE DRUMS TURN WITH NO TONER IN THE
PCU ,
S THIS CAN CAUSE THE CLEANING
BLADES TO CATCH ON A DRY DRUM AND
DAMAGE THE DRUM SURFACES
4. With the front door open, turn ON the
main power switch.
SM
- .
CHECK
,
THE
.
1-31
COPIER B132/B200
[A]
[B]
[C]
Open Door Before Power ON!
B132I719.WMF
B132I720.WMF
B132I721.WMF
B132/B200