Up Mode Settings For Wireless Lan - Ricoh B132 Service Manual

MFP CONTROLLER OPTIONS

UP Mode Settings for Wireless LAN

Enter the UP mode and follow the procedure below to perform the initial interface
settings for IEEE 802.11. These settings take effect every time the machine is
powered on.
NOTE: The wireless LAN cannot be used if Ethernet is being used.
1. Press the User Tools/Counter key.
2. On the touch panel, press System Settings.
NOTE: The Network I/F (default: Ethernet) must be set for either Ethernet or
wireless LAN.
3. Select Interface Settings ! Network (tab) ! Network I/F Settting
4. Select either "Ethernet" or "IEEE 802.11b".
5. Press IEEE 802.11b. Only the wireless LAN options are displayed.
System Intialization Settings
Select the desired settings.
Network
Transmission Speed
SSID Setting
Channel
WEP (Privacy) Setting
6. Transmission Mode. Select either "Ad Hoc Mode" or "Infrastructure Mode".
7. SSID Setting. Enter the SSID setting. (The setting is case sensitive.)
8. Channel. This setting is required when Ad Hoc Mode is selected.
Range: 1 ~ 14 (default: 11)
NOTE: The allowed range for the channel settings may vary for different
countries.
9. WEP (Privacy) Setting. The WEP (Wired Equivalent Privacy) setting is
designed to protect wireless data transmission. In order to unlock encoded
data, the same WEP key is required on the receiving side. There are 64 bit and
128 bit WEP keys.
Range of Allowed Settings:
64 bit 10 characters
128 bit 26 characters
B132/B200
Parallel Interface IEEE 1394
802.11 Ad Hoc Mode
ASSID
11
Disabled
IEEE 802.1b
Bandwidth Status
1-134
End
1/2
Previous Next
B064I997.WMF
SM