COPIER INSTALLATION
1.2.3 INSTALLATION SP SETTINGS
Using the SP Mode
To go into and use the SP mode
1. Push
.
2. Push .
3. Push and hold for 3 seconds.
4. Input the group number ("1" for "Copier"). Then input the full SP number to go
directly to the SP code screen.
5. To input an SP number:
• Do not put a hyphen (-) between the first 4 digits and the last 3 digits.
• If the 2nd half of the SP code is only 1 or 2 digits, input the zeros that are in
front. For example, if the 2nd number is 1 or 12, push or .
• If you input only the first 4 digits of an SP that has some sub levels, the first
SP code (001) will be shown. Push the key below "PrevMenu" or
"NextMenu" to show the SP. Then push the key below "Set" or push .
6. Set the adjustment value.
• If a minus sign (-) is necessary, push to change the +/- sign.
• If a decimal point is necessary, do not push the decimal point button. For
example, to input "-1.3", push for the minus sign, then push .
• If you make an error, push to reset the setting, then try again. You cannot
correct it with a new entry.
7. Push the key below "Set" on the LCD, or push to enable the setting that
you made.
To go out of SP mode
1. Push the key on the operation panel below "Exit" one time or more, until you
are back at the initial copy screen.
2. Switch the main power switch off, then switch it on again.
NOTE: You must do this to enable the SP values that you input.
B125
1-18
SM