Opening And Locking The Controller Box Cover - Ricoh B132 Service Manual

3.2.11 OPENING AND LOCKING THE CONTROLLER BOX COVER

[A]
CAUTION: 1) Before you start this procedure, turn off the main power
switch and disconnect the power cord.
2) To prevent personal injury and damage to the controller box,
when the controller box is open, it should always be locked as
described below.
1. Remove the rear covers (!3.2.6)
2. Remove controller box screws
3. Open the controller box [A] to the left until it stops.
Important! Obey the warning on the decal to avoid touching the fan blades
when you open and close the controller box.
4. Remove the left screw [B] of the plastic stopper arm [C].
5. Rotate the plastic stopper counter-clockwise until it is aligned with the hole
below and its tip [D] is touching the machine frame.
6. Reattach the screw removed in Step 4 to lock the arm in position.
Reinstallation
• Be sure to reattach the stopper arm at its original position before you close the
controller box.
SM
COMMON REMOVAL PROCEDURES
[B]
[C] [D]
"
#
$
" # $ .
3-23
B132R715.WMF
B132/B200