Table of Contents
Advertisement
SP MODE SETTINGS AFTER REPLACING AN NVRAM
5.6 SP MODE SETTINGS AFTER REPLACING AN NVRAM
5.6.1 NVRAM FOR THE ACU
When the NVRAM for the ACU is replaced, the following data will disappear:
• Machine code, Serial number, option setting, optional counter
After you replace the NVRAM, do the following SP modes:
1. SP7-1-1 Memory Clear - Factory setting: Clears the setting so that the electrical
counter will reset and start to count. The electrical counter will not count unless
you do this procedure.
2. 2-4-1 Machine Code Setting: When the machine code is set, the destination,
language, and so on will be set automatically, so that all the settings do not
have to be set individually.
3. 3-1-1 Serial Number: Set the machine's serial number.
5.6.2 NVRAM FOR THE ECU
When the NVRAM for the ECU is replaced, the settings that were made at the
factory for this machine will disappear. (These settings are written on the sheet of
paper under the front cover.)
Set all the SP modes according to the sheet of paper under the front cover.
C262/C265
5-60
SM
Advertisement
Table of Contents
