Ricoh FT7770 Service Manual page 490

5. Remove the copier lower rear cover (2 screws) and the cover plate [A] (2
screws).
6. Feed the sorter stapler power cord [B] through the opening in the cover
plate until the cord stopper [C] reaches the opening. Then invert the
opening faces down and install it (2 screws).
7. Connect the 2P free connectors [D] and secure the ground wire [E] on the
copier base plate (1 ground screw with tooth washer).
8. Remove the three plastic covers [F] from the lower right cover of the
copier. Connect the fiber optic cables [G] to the copier through the
upper opening with the brown connector [H] connected to the rear
terminal and the black connector [I] to the front terminal.
9. Reinstall the copier lower rear cover.
Caution: Before docking the sorter stapler with the copier, open the copier top unit to
prevent damage to the sorter stapler entrance guide plates.
10. Dock the sorter stapler with the copier.
are seated firmly in the notches [K] in the copier frame.
copier top unit.
Make sure the docking pins [J]
11-31
30 April, '89
Close the