Table of Contents
Advertisement
30 April, '89
3. Feed Roller Replacement
1.
Remove the paper feed unit. (Refer to "Paper Feed Unit Removal.")
2.
Remove the tray lift and overrun sensors mounting bracket [A] (4
screws).
3.
Open the upper relay roller unit [B] and remove the upper plate [C].
4.
Remove the two E-rings [D] from the feed shaft.
5.
Loosen the two Allen screws on the feed shaft gears [E] and remove the
paper feed clutch male connector [F] from the bracket.
6.
Slide out the feed shaft [G] and remove the old feed roller [ H ] .
7.
After Installing the new feed roller, make sure that it can rotate freely
in the direction of the arrow as shown.
CAUTION: When reinstalling the feed shaft, check that the feed clutch stopper is
NOTE: Before tightening the Allen screws on the feed shaft gears, check the feed
roller thrust play adjustment (A:0.2-0.3mm, B:0.1-0.2mm).
positioned on the arm.
8-20
Advertisement
Chapters
Table of Contents
