Ricoh FT7770 Service Manual page 222

14.
Insert the beads of the long (gray) [A] and short (black) [B] wires into the slots of the
scanner drive pulley [C] as shown.
should be facing up.)
15. Wrap the two wires side by side 3 times along the grooves of the scan-
ner drive pulley.
NOTE: If the wires are properly wrapped, you will count seven wires on the scan-
ner drive pulley with the long wire to the outside of the scanner drive
pulley.
16. Clamp the wires with the scanner drive pulley clamp [E].
17. Reinstall the scanner drive pulley and insert the scanner drive pulley pin
[F] into the support shaft [G].
(At this time the Allen screw [D]
5-9
30 April, '89