Side Marker Lamp Unit Removal; Installation; Side Marker Lamp Removal; Side Repeater Lamp Description - Chrysler Vehicle User Manual

TJ
LEFT MULTI-FUNCTION SWITCH (Continued)
Fig. 32 Shroud Remove/Install
1 - UPPER SHROUD
2 - LOWER SHROUD
fully raised position and secure it in place by moving
the tilt release lever back to the locked (up) position.
(12) Reinstall the steering column opening cover
onto the instrument panel. (Refer to 23 - BODY/IN-
STRUMENT PANEL/STEERING COLUMN OPEN-
ING COVER - INSTALLATION).
(13) Reconnect the battery negative cable.
SIDE MARKER LAMP UNIT
REMOVAL
(1) Disconnect and isolate the battery negative
cable.
(2) From underside of the fender flare, remove nut
attaching marker/repeater lamp to fender.
(3) Separate lamp from fender flare.
(4) Rotate bulb socket one-third turn counter-clock-
wise and separate socket from lamp housing.

INSTALLATION

(1) Position bulb socket in lamp housing and
rotate bulb socket one-third turn clockwise.
(2) Position lamp in fender flare.
(3) Install nut attaching marker/repeater lamp to
fender flare.
(4) Connect battery negative cable.
LAMPS/LIGHTING - EXTERIOR
SIDE MARKER LAMP
REMOVAL
(1) Disconnect and isolate the battery negative
cable.
(2) Remove side marker bulb socket from the
underside of the fender flare. Rotate it one-third turn
counter-clockwise and separate it from the side
marker/repeater lamp housing.
(3) Remove the bulb from the socket by pulling it
straight outward.
INSTALLATION
(1) Install a replacement bulb in the socket by
pushing bulb into the socket.
(2) Install the bulb and socket in the side marker/
repeater lamp housing and rotate one third turn
clockwise.
(3) Connect the battery negative cable.
SIDE REPEATER LAMP
DESCRIPTION
Some vehicles are equipped with side repeater
lamps. One side repeater lamp can be found on each
side of the vehicle just above the front wheel. On
domestic vehicles, the side repeater lamp is know as
the side marker lamp, they just operate differently.
The side repeater lamp operates along with the turn
signals and utilize an amber colored housing and
clear bulb.

OPERATION

The side turn signal repeater lamps operate in
series with the front and rear turn signal lamps.
These lamps are controlled by the steering column
mounted multi-function switch. Refer to Wiring Dia-
grams for a complete schematic.
DIAGNOSIS AND TESTING
SIDE TURN SIGNAL REPEATER LAMP
DIAGNOSIS
The following test is designed to diagnosis a faulty
side repeater lamp with the turn signals operating
normally. Refer to Wiring Diagrams for a complete
system schematic.
8L - 31