Cable Description; Operation; Removal; Installation - Chrysler Vehicle User Manual

TJ
CABLE

DESCRIPTION

The speed control servo cable is connected between
the speed control vacuum servo diaphragm and the
throttle body control linkage.

OPERATION

This cable causes the throttle control linkage to
open or close the throttle valve in response to move-
ment of the vacuum servo diaphragm.

REMOVAL

2.4L
(1) Disconnect negative battery cable at battery.
(2) Hold throttle in wide open position. While held
in this position, slide throttle control cable pin (Fig.
1) from throttle body bellcrank. Also slide servo cable
pin from throttle body bellcrank.
(3) Using a pick or small screwdriver, press release
tab (Fig. 1) to release plastic cable mount from
bracket. Press on tab only enough to release
cable from bracket. If tab is pressed too much,
it will be broken. To remove throttle cable from
throttle body bracket, slide cable towards front of
vehicle.
(4) After removing throttle control cable at throttle
body, slide servo cable from throttle body.
(5) If necessary, disconnect opposite end of servo
cable at servo. Refer to Servo Removal/Installation.
4.0L
(1) Disconnect negative battery cable at battery.
(2) Using finger pressure only, remove cable con-
nector by pushing connector off the throttle body
bellcrank pin (Fig. 2). DO NOT try to pull cable
connector off perpendicular to the bellcrank
pin. Connector will be broken.
(3) Two release tabs are located on sides of speed
control cable at cable bracket (Fig. 2). Squeeze tabs
together and push cable out of bracket.
(4) Unclip cable from cable guide at valve cover.
(5) If necessary, disconnect opposite end of servo
cable at servo. Refer to Servo Removal/Installation.

INSTALLATION

2.4L
(1) Install end of cable to speed control servo.
Refer to Servo Removal/Installation.
(2) Slide speed control cable plastic mount into
throttle body bracket.
(3) Install speed control cable connector onto throt-
tle body bellcrank pin (push rearward to snap into
location).
Fig. 1 SERVO CABLE AT THROTTLE BODY - 2.4L
1 - MOUNTING BRACKET
2 - SPEED CONTROL CABLE
3 - THROTTLE CABLE
4 - RELEASE TAB
5 - CABLE PINS
6 - BELLCRANK
Fig. 2 SERVO CABLE AT THROTTLE BODY - 4.0L
1 - ACCELERATOR CABLE
2 - OFF
3 - OFF
4 - THROTTLE BODY BELLCRANK
5 - SPEED CONTROL CABLE
6 - RELEASE TABS
7 - BRACKET
SPEED CONTROL 8P - 3