Removal - Chrysler Vehicle User Manual

TJ
LEFT MULTI-FUNCTION SWITCH (Continued)
Headlamp Low Beams On
Headlamp High Beams On
Fog Lamps On
Rear Fog Lamps On
Optical Horn On
SWITCH POSITION
Panel Lamps Dimming Position 1 (Dimmest)
Dimming Position 2
Dimming Position 3
Dimming Position 4
Dimming Position 5
Dimming Position 6 (Brightest)
Parade Mode On
Courtesy Lamps On
(5) If the left multi-function switch fails any of the
continuity or resistance tests, replace the faulty
switch unit as required.

REMOVAL

WARNING: ON VEHICLES EQUIPPED WITH AIR-
BAGS, DISABLE THE AIRBAG SYSTEM BEFORE
ATTEMPTING ANY STEERING WHEEL, STEERING
COLUMN, OR INSTRUMENT PANEL COMPONENT
DIAGNOSIS OR SERVICE. DISCONNECT AND ISO-
LATE THE BATTERY NEGATIVE (GROUND) CABLE,
THEN WAIT TWO MINUTES FOR THE AIRBAG SYS-
TEM CAPACITOR TO DISCHARGE BEFORE PER-
FORMING FURTHER DIAGNOSIS OR SERVICE. THIS
IS THE ONLY SURE WAY TO DISABLE THE AIRBAG
SYSTEM. FAILURE TO TAKE THE PROPER PRE-
CAUTIONS COULD RESULT IN ACCIDENTAL AIR-
BAG DEPLOYMENT AND POSSIBLE PERSONAL
INJURY.
(1) Disconnect and isolate the battery negative
cable.
(2) Remove the steering column opening cover
from the instrument panel. (Refer to 23 - BODY/IN-
STRUMENT PANEL/STEERING COLUMN OPEN-
ING COVER - REMOVAL).
(3) Remove the two screws that secure the lower
steering column shroud to the upper shroud (Fig. 30).
LEFT (LIGHTING) MULTI-FUNCTION SWITCH TEST
TURN SIGNAL AND HAZARD WARNING SWITCH TESTS
INTERIOR LIGHTING SWITCH TESTS
LAMPS/LIGHTING - EXTERIOR
B16 & B18, B16 & B19
B17 & B18, B17 & B19
B17 & B18, B17 & B19
RESISTANCE
BETWEEN
B7 & B8
B7 & B8
B7 & B8
B7 & B8
B7 & B8
B7 & B8
B7 & B8
B7 & B8
Fig. 30 Steering Column Shrouds Remove/Install
1 - LEFT MULTI-FUNCTION SWITCH
2 - UPPER SHROUD
3 - RIGHT MULTI-FUNCTION SWITCH
4 - CLOCKSPRING
5 - IGNITION LOCK CYLINDER HOUSING
6 - LOWER SHROUD
7 - SCREW (2)
B13 & B14
B12 & B13
RESISTANCE (OHMS)
5653 ± 10%
3743 ± 10%
2593 ± 10%
1825 ± 10%
1221 ± 10%
768 ± 10%
412 ± 10%
150 ± 10%
8L - 29