Installation - Chrysler Vehicle User Manual

8O - 36 RESTRAINTS
SEAT BELT TURNING LOOP ADJUSTER (Continued)
(1) Unsnap and lift the trim cover from the front
seat belt turning loop to access the screw that
secures the turning loop to the height adjuster on the
upper sport bar (Fig. 42).
Fig. 42 Front Turning Loop Height Adjuster
1 - ADJUSTER
2 - SPORT BAR
3 - TRIM COVER
4 - TURNING LOOP
(2) Remove the screw that secures the shoulder
belt turning loop to the height adjuster.
(3) Remove the front seat belt turning loop and the
support/guide washer from the height adjuster.
(4) Unsnap and remove the trim cover from the
front seat belt turning loop height adjuster to access
the screws that secure the adjuster to the upper
sport bar.
(5) Remove the two screws that secure the height
adjuster to the upper sport bar.
(6) Remove the front seat belt turning loop height
adjuster from the upper sport bar.

INSTALLATION

WARNING: DURING AND FOLLOWING ANY SEAT
BELT OR CHILD RESTRAINT ANCHOR SERVICE,
CAREFULLY INSPECT ALL SEAT BELTS, BUCKLES,
MOUNTING HARDWARE, RETRACTORS, TETHER
STRAPS, AND ANCHORS FOR PROPER INSTALLA-
TION, OPERATION, OR DAMAGE. REPLACE ANY
BELT THAT IS CUT,
STRAIGHTEN ANY
TIGHTEN ANY LOOSE FASTENERS. REPLACE ANY
BELT THAT HAS A DAMAGED OR INOPERATIVE
BUCKLE OR RETRACTOR. REPLACE ANY BELT
THAT HAS A BENT OR DAMAGED LATCH PLATE
OR ANCHOR PLATE.
RESTRAINT ANCHOR OR THE UNIT TO WHICH THE
ANCHOR IS INTEGRAL THAT HAS BEEN BENT OR
DAMAGED. NEVER ATTEMPT TO REPAIR A SEAT
BELT OR CHILD
ALWAYS REPLACE DAMAGED OR FAULTY SEAT
BELT AND CHILD RESTRAINT COMPONENTS WITH
THE CORRECT, NEW AND UNUSED REPLACEMENT
PARTS LISTED IN THE DAIMLERCHRYSLER MOPAR
PARTS CATALOG.
(1) Position the front seat belt turning loop height
adjuster onto the upper sport bar (Fig. 42). Be cer-
tain that the word "Up" stamped on the adjuster is
properly oriented.
(2) Install and tighten the two screws that secure
the seat belt turning loop height adjuster to the
upper sport bar. Tighten the screws to 43 N·m (32 ft.
lbs.).
(3) Align the trim cover over the front seat belt
turning loop height adjuster and, using hand pres-
sure, press firmly and evenly on the cover until it
snaps into place over the adjuster on the upper sport
bar.
(4) Position the support/guide washer and the
front seat belt turning loop onto the height adjuster.
(5) Install and tighten the screw that secures the
front seat belt turning loop to the height adjuster.
Tighten the screw to 43 N·m (32 ft. lbs.).
(6) Fold and snap the trim cover for the seat belt
turning loop back into place over the screw that
secures the turning loop to the height adjuster.
FRAYED, OR
BELT THAT IS TWISTED.
REPLACE ANY
RESTRAINT COMPONENT.
TJ
TORN.
CHILD