Installation; Rear Wiper/Washer Switch Description - Chrysler Vehicle User Manual

8R - 40 REAR WIPERS/WASHERS
REAR WIPER MOTOR TRIM COVER (Continued)
Fig. 21 Rear Wiper Motor Trim Cover Remove/Install
1 - SCREW (3)
2 - TRIM COVER
3 - REAR WIPER MOTOR
4 - LIFTGLASS

INSTALLATION

(1) From the inside of the liftglass, position the
trim cover onto the rear wiper motor mounting
bracket (Fig. 21).
(2) Install and tighten the three screws that secure
the trim cover to the rear wiper motor mounting
bracket. Tighten the screws to 1 N·m (10 in. lbs.).
REAR WIPER/WASHER
SWITCH
DESCRIPTION
The rear wiper and washer switch is located in the
accessory switch bezel near the bottom of the instru-
ment panel center stack area on the instrument
panel (Fig. 22). Only the single switch toggle button
is visible through the opening of the accessory switch
bezel (Fig. 23). The remainder of the switch is con-
cealed behind the accessory switch bezel within the
instrument panel. The single two-function switch
housing and switch toggle button are molded from
black plastic. The switch toggle button is clearly
identified by a white graphic of the International
Control and Display Symbol icon for "Rear Wiper and
Washer," making it clearly visible in daylight. When
illuminated from behind by an integral panel lamps
dimmer controlled illumination lamp with the exte-
rior lamps turned On, the white graphic appears
blue-green.
The rear wiper and washer switch is secured by a
snap fit within a dedicated receptacle molded into
the back of the accessory switch bezel. A single six
pin connector receptacle is molded into the back of
Fig. 22 Accessory Switch Bezel
1 - ACCESSORY SWITCH BEZEL
2 - REAR WINDOW DEFOGGER SWITCH (HARDTOP ONLY)
3 - REAR WIPER/WASHER SWITCH (HARDTOP ONLY)
4 - OVERDRIVE-OFF SWITCH (AUTOMATIC TRANSMISSION
ONLY)
5 - AXLE LOCK SWITCH (OFF ROAD PACKAGE ONLY)
6 - PASSENGER AIRBAG ON/OFF SWITCH (WITHOUT REAR
SEAT ONLY)
7 - ACCESSORY POWER OUTLET
8 - CIGAR LIGHTER
Fig. 23 Rear Wiper/Washer Switch
1 - CONNECTOR RECEPTACLE
2 - HOUSING
3 - TOGGLE BUTTON
the switch housing. A dedicated take out and connec-
tor of the instrument panel wire harness connects
the switch to the vehicle electrical system. The rear
wiper and washer switch contains switches and cir-
cuitry to control both the rear wiper and the rear
washer functions. The rear wiper and washer switch
cannot be repaired and, if faulty or damaged, the
entire switch unit must be replaced. The incandes-
cent switch illumination bulb and bulb holder unit is
available for individual service replacement.
TJ