Chrysler Vehicle User Manual page 253

5 - 44 BRAKES - ABS
FRONT WHEEL SPEED SENSOR (Continued)
(3) Position sensor on steering knuckle. Seat sen-
sor locating tab in hole in knuckle and install sensor
attaching bolt finger tight.
(4) Tighten sensor attaching bolt to 4-6 N·m (34-50
in. lbs.).
(5) If original sensor has been installed, check sen-
sor air gap. Air gap should be 0.40 to 1.3 mm (0.0157
to 0.051 in.). If gap is incorrect, sensor is either loose,
or damaged.
(6) Route sensor wire and install into mounting
retainers.
(7) Connect sensor wire to harness.
G-SWITCH
DESCRIPTION
The G-switch is located in front of the console/
shifter mounted to a bracket on the floor pan. The
switch has directional arrow and must be mounted
with the arrow pointing towards the front of the
vehicle.
OPERATION
The switch (Fig. 3) , provides an additional vehicle
deceleration reference during 4-wheel drive opera-
tion. The switch is monitored by the CAB at all
times. The switch reference signal is utilized by the
CAB when all wheels are decelerating at the same
speed.
REMOVAL
(1) From the drivers side lift carpet back in front
of the console/shifter.
(2) Disconnect harness for switch.
(3) Remove mounting bolts and remove switch
(Fig. 4).
INSTALLATION
CAUTION: The mercury
G-switch), will not function properly if the switch is
installed incorrectly. Verify that the switch locating
arrow is pointing to the front of the vehicle (Fig. 3).
(1) Position switch on mounting bracket.
switch (inside the
Fig. 3 G-Switch
1 - SWITCH PART NUMBER
2 - ARROW INDICATES FRONT OF SWITCH FOR PROPER
MOUNTING
Fig. 4 G-Switch
1 - ACCELERATION SWITCH
2 - MOUNTING BRACKET
(2) Install mounting bolts and tighten to 4-5 N·m
(35-45 in. lbs.)
(3) Connect harness to switch.
(4) Place carpet back into position.
TJ