Chrysler Vehicle User Manual page 94

TJ
DIFFERENTIAL (Continued)
(8) Position Spreader W-129-B, utilizing some
items from Adapter Kit 6987, with the tool dowel
pins seated in the locating holes (Fig. 36). Install the
holddown clamps and tighten the tool turnbuckle fin-
ger-tight.
Fig. 36 SPREADER LOCATION
1 - AXLE HOUSING
2 - DOWEL
3 - SAFETY HOLD DOWN
4 - SPREADER
5 - TURNBUCKLE
(9) Install a Pilot Stud C-3288-B at the left side of
the differential housing. Attach Dial Indicator C-3339
to guide pin. Load the lever adapter against the
opposite side of the housing (Fig. 37) and zero the
indicator.
CAUTION: Do not spread over 0.50 mm (0.020 in). If
the housing is over-spread it could be distorted or
damaged.
(10) Spread the housing enough to remove the dif-
ferential case from the housing. Measure the dis-
tance with the dial indicator (Fig. 38).
(11) Remove the dial indicator.
(12) Hold the differential case in position while
removing the differential bearing cap bolts and caps.
FRONT AXLE - 181FBI
Fig. 37 DIAL INDICATOR LOCATION
1 - SPECIAL TOOL
C-3339
2 - DIAL INDICATOR
3 - LEVER ADAPTER
4 - SPECIAL TOOL
W-129–B
5 - SPECIAL TOOL
C-3288–B
Fig. 38 SPREAD DIFFERENTIAL HOUSING
1 - SPECIAL TOOL
C-3339
2 - SPECIAL TOOL
W-129–B
3 - 35