Chrysler Vehicle User Manual page 90

TJ
PINION SEAL (Continued)
Fig. 23 PINION YOKE REMOVER
1 - WRENCH
2 - PINION YOKE
3 - REMOVER
INSTALLATION
(1) Apply a light coating of gear lubricant on the
lip of pinion seal. Install seal with an appropriate
installer (Fig. 24).
Fig. 24 PINION SEAL INSTALLER
1 - HANDLE
2 - INSTALLER
(2) Install yoke on the pinion gear with Installer
W-162-D, Cup 8109 and Holder 6958 (Fig. 25).
CAUTION: Do not exceed the minimum tightening
torque when installing the pinion yoke retaining nut
at this point. Damage to the pinion bearings may
result.
(3) Install the pinion washer and a new nut on
the pinion gear shaft. Tighten the nut only
enough to remove the shaft end play.
(4) Tighten pinion nut to 217 N·m (160 ft. lbs.).
FRONT AXLE - 181FBI
Fig. 25 PINION YOKE INSTALLER
1 - INSTALLER
2 - PINION YOKE
3 - SPANNER WRENCH
(5) Rotate the pinion shaft using an inch pound
torque wrench. Rotating torque should be equal to
the reading recorded during removal, plus an addi-
tional 0.56 N·m (5 in. lbs.) (Fig. 26).
Fig. 26 PINION ROTATING TORQUE
1 - TORQUE WRENCH
2 - PINION YOKE
3 - 31