Adjustments - Chrysler Vehicle User Manual

TJ
LAMPS/LIGHTING - EXTERIOR (Continued)
CONDITION
*Canada vehicles must have lamps ON.

ADJUSTMENTS

HEADLAMP ALIGNMENT PREPARATION
NOTE: If the vehicle is equipped with a headlamp
leveling system, be certain the headlamp leveling
switch is in the "0" position.
(1) Verify headlamps are operational in all modes
and illuminated in the low beam setting.
(2) Correct defective components that could hinder
proper headlamp alignment.
1 - CENTER OF VEHICLE TO CENTER OF HEADLAMP LENS
2 - FLOOR TO CENTER OF HEADLAMP LENS
3 - 7.62 METERS (25 FEET)
POSSIBLE CAUSES
3. Faulty headlamp switch.
4. Faulty headlamp dimmer
(multi-function) switch.
5. Broken connector terminal or wire
splice in headlamp circuit.
6. Both headlamp bulbs faulty.
Fig. 2 Headlamp Alignment Screen -Typical
LAMPS/LIGHTING - EXTERIOR
3. Replace headlamp switch. (Refer to 8 -
ELECTRICAL/LAMPS/LIGHTING -
EXTERIOR/HEADLAMP SWITCH -
REMOVAL)
4. Replace multi-function switch.
5. Repair connector terminal or wire splice.
6. Replace both headlamp bulbs.
(3) Verify proper tire inflation.
(4) Clean headlamp lenses.
(5) Verify that luggage area is not heavily loaded.
(6) Fuel tank should be FULL. Add 2.94 kg (6.5
lbs.) of weight over the fuel tank for each estimated
gallon of missing fuel.
ALIGNMENT SCREEN PREPARATION
(1) Position vehicle on a level surface perpendicu-
lar to a flat wall 7.62 meters (25 ft.), export vehicles
use 10 meters (32.8 ft.), away from front of headlamp
lens (Fig. 2).
4 - FRONT OF HEADLAMP
5 - VEHICLE CENTERLINE
CORRECTION
8L - 7